Construction Waste Crusher if used improper maintenance, will greatly improve the incidence of failure, seriously affecting the reliability and service life of the machine. So you must regularly check the quality of hydraulic oil to keep the hydraulic oil clean. In the inspection of hydraulic oil quality, the main check the following three aspects:

 (1) Hydraulic Cone Crusher Oil Oxidation Degree. To determine the degree of oxidation of hydraulic oil, usually from its color, smell on the start. If the color of the hydraulic oil is dark brown, and there is a bad smell that has been oxidized. The darker the darker the darker the odor, the more severe the degree of oxidation, and the new oil should be replaced.

 (2) Construction Waste Crusher oil moisture content. To determine the amount of water mixed with hydraulic oil, there are usually two ways:

(1) according to its color and odor changes, such as the color of hydraulic oil was milky white, smell did not change, then that too much water;

(2) take a small amount of hydraulic oil droplets in the burning iron plate, if issued "bao" sound, then that contains water. At this point, should replace the new oil.

(3) The hydraulic oil contains impurities. To determine the presence of impurities in the hydraulic oil, there are two ways:

 (1) in the mechanical work for some time, take a few drops of hydraulic oil on the hand, twist with your fingers to see if there are metal particles;

(2) in the sun to see if there is a small flash point. If there is more metal particles or flash point, it proves that the hydraulic oil contains more mechanical impurities. At this point should be timely replacement of hydraulic oil, or the release of hydraulic oil, not less than 24 hours of precipitation, and then use it after filtration.